Tahoe 2WD V8-5.3L (2007)
Notice: Refer to Fastener Notice.
3. Install the brake caliper bracket mounting bolts (2).
Tighten the bolts to 300 N.m (221 lb ft).
4. Install NEW brake pad retaining springs to the brake caliper bracket.
5. Install the brake pads. Refer to Front Disc Brake Pads.
6. Slowly apply pressure to the brake pedal until a firm pedal as been achieved.
7. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling.
8. Install the tire and wheel assembly.
Rear Brake Caliper Bracket Replacement (1500 Series)
Rear Brake Caliper Bracket Replacement (1500 Series)
Caution: Refer to Brake Dust Caution.
Removal Procedure
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the fluid level is midway between the maximum - full point and the minimum allowable level, no fluid needs to be removed from the reservoir
before proceeding.
3. If the fluid level is higher than midway between the maximum - full point and the minimum allowable level, remove fluid to the midway point
before proceeding.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
5. Remove the tire and wheel assembly.
6. Compress the brake caliper pistons.
1. Install a large C-clamp over the top of the caliper housing and against the back of the outboard pad.
2. Slowly tighten the C-clamp until the pistons are pushed completely into the caliper bores.
3. Remove the C-clamp from the caliper.
