Tahoe 2WD V8-5.3L (2007)
Notice: Refer to Fastener Notice.
9. Install the bleeder valve in the brake caliper housing.
Tighten the bleeder valve to 12 N.m (106 lb in).
10. Install the bleeder valve cap.
11. Install the brake caliper.
Rear Brake Caliper Overhaul (2500 Series)
Rear Brake Caliper Overhaul (2500 Series)
Caution: Refer to Brake Dust Caution.
Caution: Refer to Brake Fluid Irritant Caution.
Disassembly Procedure
1. Remove the brake caliper.
2. Drain all the brake fluid from the caliper.
Important: The brake calipers use phenolic pistons with stainless steel caps which contact the brake pads. Use compressed air to remove
the piston from the brake caliper.
3. Secure the brake caliper in a suitable holding device.
4. Insert a piece of wood in the brake caliper between the pistons and the outer bridge.
