Tahoe 2WD V8-5.3L (2007)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve Replacement (W/O JL4)
Brake Pressure Modulator Valve Replacement (W/O JL4)
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice.
Important: Cap the brake pipe fittings to prevent brake fluid loss and contamination.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Clean all dirt and debris from the brake pressure modulator valve (BPMV) assembly and the brake pipe fittings.
3. Disconnect the electronic brake control module (EBCM) electrical connector.
Important: Note the location of the brake pipes to the BPMV for proper installation.
4. Release the brake pipe retaining clip (1) from the frame.
5. Disconnect the rear brake pipe fitting (2) from the BPMV (4).
6. Remove the rear brake pipe (3) from the BPMV (4).
