Tahoe 2WD V8-5.3L (2007)
6. Install the catalytic converter to the exhaust manifold studs.
7. Install the catalytic converter to exhaust manifold nuts (2).
Tighten the nuts to 50 N.m (37 lb ft).
8. Install the right rear HO2S electrical connector clip to the engine harness clip (4).
9. Connect the engine wiring harness electrical connector (2) to the right rear HO2S electrical connector.
10. Install the right rear CPA retainer (3).
11. Connect the right front HO2S electrical connector to the engine wiring harness electrical connector (1).
12. Install the right front CPA retainer (5).
13. Install the muffler.
14. Install the transmission crossmember.
15. Position the oil pan skid plate and tighten until snug the 2 rear oil pan skid plate bolts, install the 2 front oil pan skid plate bolts, if equipped.
Tighten the bolts to 28 N.m (21 lb ft).
