Tahoe 2WD V8-5.3L (2007)
3. If the vehicle is a Tahoe, Yukon, Yukon Denali, or a Escalade, position the exhaust heat shield to the studs and install the heat shield nuts, as
required.
Tighten the nuts to 9 N.m (80 lb in).
4. Position the left front floor panel exhaust heat shield to the studs and install the heat shield nuts.
Tighten the nuts to 9 N.m (80 lb in).
5. Install the muffler assembly, as required.
6. Install the catalytic converter, if necessary. Refer to one of the following:
^
Catalytic Converter Replacement (1500 Series)
^
Catalytic Converter Replacement - Left Side (2500 Series)
^
Catalytic Converter Replacement - Right Side (2500 Series)