Tahoe 2WD V8-5.3L (2007)
7. Install the right rear shock absorber lower bolt and nut.
Tighten the bolt/nut to 95 N.m (70 lb ft).
8. Install the right rear stabilizer shaft link to the frame.
9. Install the right rear stabilizer shaft link to frame bolt and nut.
Tighten the bolt/nut to 65 N.m (48 lb ft).
10. Install the right rear axle tie rod bolt (2) and nut (1).
Tighten the bolt/nut to 105 N.m (77 lb ft).
11. Install the rear axle vent hose to the rear axle, if necessary.
12. Install the vent hose swivel clip to the rear brake crossover pipe, if necessary.
13. Using the J 38185 install the right rear link rod to the ball studs on the sensors.
Important: The rear axle wiring harness clip is a one way clip with a D-shape section. The clip can only be installed and/or removed in
only one direction.
14. Install the right rear wheel speed sensor wiring harness clips to the frame and the control arm bracket.
15. Install the right rear wheel speed sensor wiring harness electrical connector clip to the frame.
