Tahoe 2WD V8-5.3L (2007)
19. Install the intake manifold sight shield.
Evaporative Emission (EVAP) Hoses/Pipes Replacement - Chassis (2500 Series)
EVAPORATIVE EMISSION HOSES/PIPES REPLACEMENT - CHASSIS (2500 SERIES)
REMOVAL PROCEDURE
IMPORTANT: Clean all fuel and evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the lines in order to
avoid possible fuel and/or EVAP system contamination.
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief.
2. Disconnect the fuel feed pipe (2) quick connect fitting at the fuel rail.
3. Disconnect the EVAP line (1) quick connect fitting from the chassis line.
4. Cap the fuel rail and EVAP line in order to prevent fuel/EVAP system contamination.
5. Raise and support the vehicle. Refer to Vehicle Lifting.
6. Remove the fuel pipe bracket nut.
7. Remove the fuel pipe bracket from the bellhousing stud.
