Tahoe 2WD V8-5.3L (2007)
4. Ensure that the connector is secured.
32. Connect the engine wiring harness electrical connector (4) to the MAP sensor.
33. Connect the engine wiring harness electrical connector (3) to the generator.
34. Connect the engine wiring harness electrical connector (2) to the EVAP purge solenoid.
35. Install the engine wiring harness bracket nut (1).
Tighten the nut to 5 N.m (44 lb in).
36. Connect the negative battery cable.
37. Use the following procedure in order to inspect for leaks:
1. Turn the ignition ON, with the engine OFF for 2 seconds.
2. Turn the ignition OFF for 10 seconds.
3. Turn the ignition ON, with the engine OFF.
4. Inspect for leaks.
38. Install the air cleaner outlet duct.
