Tahoe 2WD V8-5.3L (2007)
7. Remove the propeller shaft from the vehicle.
Installation Procedure
1. Inspect the splines of the slip yoke for a sufficient coating of lubricant. If the splines of the slip yoke do not have a sufficient coating of lubricant,
lubricate the shaft with lubricant GM P/N 12345879 (Canadian P/N 10953511) or with an equivalent lubricant meeting GM specification 9985830
(RWD w/4 speed Automatic Transmission).
2. Install the propeller shaft into the transmission or transfer case.
Align the reference marks made during removal.
3. Install the propeller shaft (3) to the rear axle pinion yoke (4).
Align the reference marks made during removal.
Notice: Refer to Fastener Notice.
4. Install the yoke retainers (2) and bolts (1).
Tighten the yoke retainer bolts to 25 N.m (18 lb ft).
5. Lower the vehicle.
