Tahoe 2WD V8-5.3L (2007)
Window Seal: All Technical Service Bulletins
Body - Rear Door Window Seal Molding is Loose
Subject:
Rear Door Outer Belt Sealing Strip/Molding Bowed, Loose (Replace with New Design Outer Belt Sealing Strip/Molding)
# 06-08-64-026B - (10/10/2006)
Models:
2007 Chevrolet Avalanche, Suburban, Tahoe 2007 GMC Yukon, Yukon XL, Yukon Denali
This bulletin is being revised to add models and parts information. Please discard Corporate Bulletin Number 06-08-64-026A (Section 08 -- Body and
Accessories).
Condition
Some customers may comment that the molding on the rear door window opening is loose on the right or the left rear door.
Cause
A lack of adhesive between the window run channel and the outer belt sealing strip may cause this condition.
Correction
Replace the rear door glass outer belt molding sealing strip using the following procedure.
1.
Lower the door glass.
2.
Pull out and upward on the sealing strip end to unhook it from the door frame.
3.
If necessary, with a trim stick, push up on the belt sealing strip to remove it from the door.
4.
With a plastic trim stick, pull out the door glass run channel from the rear of the door.
5.
Install the new outer belt sealing strip on the door. The picture above shows the back side of the new molding.
