Tahoe 2WD V8-5.3L VIN Z Flex Fuel (2004)
TOOLS REQUIRED
J 38778 Door Trim Pad Clip Remover
REMOVAL PROCEDURE
1. Use the J 38778 in order to remove the rear upper garnish molding.Insert the J 38778 and work along the front edge of the trim panel from one end
to the other.
2. Remove the rear upper garnish molding from the vehicle.
INSTALLATION PROCEDURE
Install the roof rear upper garnish molding to the vehicle until it clicks into place.
Garnish Molding Replacement - Windshield Pillar
GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR
REMOVAL PROCEDURE
1. Pull the molding straight out in order to release the retainers.
2. Remove the windshield garnish molding.
INSTALLATION PROCEDURE