Tahoe 2WD V8-5.3L VIN Z Flex Fuel (2004)
Notice: During removal of the steering column the wire harness retaining clip must be removed and reinstalled after installing the steering column
or damage may occur to the wire harness.
7. Remove the wiring harness retaining pin (4) from the instrument panel.
8. Remove the wire straps and open the harness insulation to gain access to the electrical wiring.
9. Remove the wiring from the electrical connector.
10. Remove the shift lever.
Installation Procedure
1. Install the shift lever (1).
2. Connect the shifter electrical connector.
3. Install the wire straps to the harness.
4. Install the harness retaining pin (4) to the instrument panel.
