Tahoe 2WD V8-5.3L VIN Z Flex Fuel (2004)
2. Install the inner pinion bearing cup using the J 45870, 8.6 inch axle, or the J 22306, 9.5 inch axle (2), and the J8092(1).
3. Determine the selective shim thickness for the drive pinion.
4. Install the selective shim between the inner pinion bearing and the shoulder on the gear.
5. Install the inner pinion bearing using the J 24433 or the J 36614.
Press the bearing on until the cone seats on the pinion shim.
6. Install a new collapsible spacer.
7. Lubricate the pinion bearings with axle lubricant. Use the proper fluid.
8. Install the outer pinion bearing into the axle housing.
9. Install a new pinion oil seal using the J22388.
10. Install the pinion into the axle housing.
11. Apply sealant, ream P/N 12346004 (Canadian P/N 10953480) or equivalent to the splines of the pinion yoke.
