Tahoe 2WD V8-6.0L Hybrid (2008)
Brake Caliper: Removal and Replacement
Front Brake Caliper Replacement (1500 Series)
Front Brake Caliper Replacement (1500 Series)
Caution: Refer to Brake Dust Caution .
Caution: Refer to Brake Fluid Irritant Caution .
Removal Procedure
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the
reservoir before proceeding.
3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the
midway point before proceeding.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
6. Compress the brake caliper pistons.
1. Install 2 large C-clamps over the top of the caliper housing and against the back of the outboard pad.
2. Slowly tighten the C-clamps until the pistons are pushed completely into the caliper bores.
3. Remove the C-clamps from the caliper.
7. Clean all dirt and foreign material from the brake caliper.
Important: Cap or plug the brake hose to prevent brake fluid loss and contamination.
