Tahoe 2WD V8-6.0L Hybrid (2008)
45. Connect the engine wiring harness electrical connector (3) to the MAP sensor.
46. Connect the engine harness electrical connector (2) to the EVAP canister purge solenoid.
47. Install the engine harness retainer to the stud and locator pin.
48. Install the engine harness retainer nut (1).
Tighten the nut to 5 N.m (44 lb in).
49. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
50. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection .
