Tahoe 2WD V8-6.0L Hybrid (2008)
Timing Cover: Service and Repair
Engine Front Cover Replacement
Engine Front Cover Replacement
Special Tools
J 41476 Front and Rear Cover Alignment Tool
Removal Procedure
1. Remove the water pump. Refer to Water Pump Replacement (RPOs LY2/LC9/LY5/LMG/LFA) (See: Water Pump/Service and Repair)Water
Pump Replacement (RPOs LY6/L76/L92) (See: Water Pump/Service and Repair) .
2. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement (See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft
Pulley/Service and Repair) .
3. Disconnect the camshaft position sensor wire harness electrical connector (1) from the CMP actuator magnet.
4. Disconnect the engine harness electrical connector (2) from the CMP sensor wire harness electrical connector.
5. Remove the oil pan-to-front cover bolts (1).
