Tahoe 2WD V8-6.0L Hybrid (2008)
14. Remove the CMP sensor (703).
15. Remove the CMP actuator magnet bolts (751), and magnet (752).
16. Remove and discard the CMP actuator magnet gasket (753).
Installation Procedure
Important:
*
Do not reuse the crankshaft oil seal or front cover gasket.
*
Do not apply any type of sealant to the front cover gasket, unless specified.
*
The special tool in this procedure is used to properly center the front crankshaft front oil seal.
-
All gasket surfaces should be free of oil or other foreign material during assembly.
