Tahoe 2WD V8-6.0L Hybrid (2008)
Exhaust Resonator: Service and Repair
Resonator Replacement
Special Tools
J 38185 Hose Clamp Pliers
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the chassis wiring harness electrical connector (1) from the right rear wheel speed sensor wiring harness electrical connector (2).
3. Remove the right rear wheel speed sensor wiring harness electrical connector clip from the frame.
Important: The rear axle wiring harness clip is a one way clip with a D-shape section. The clip can only be installed and/or removed in
only one direction.
