Tahoe 2WD V8-6.0L Hybrid (2008)
8. Fill the brake master cylinder reservoir to the maximum-fill level with Delco Supreme 11(R), GM P/N 12377967 (Canadian P/N 992667), or
equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.
9. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) (See: )Hydraulic Brake System Bleeding (Manual) (See:
) .
10. With the ignition OFF, apply the brakes 3-5 times, or until the brake pedal becomes firm, in order to deplete the brake booster power reserve.
11. Slowly depress and release the brake pedal. Observe the feel of the brake pedal.
12. If the brake pedal feels spongy, repeat the automated bleeding procedure. If the brake pedal still feels spongy after repeating the automated
bleeding procedure inspect the brake system for external leaks. Refer to Brake System External Leak Inspection (See: Brakes and Traction
Control/Hydraulic System/Testing and Inspection/Component Tests and General Diagnostics/Brake System External Leak Inspection) .
13. Turn the ignition key ON, with the engine OFF; check to see if the brake system warning lamp remains illuminated.
14. If the brake system warning lamp remains illuminated, DO NOT allow the vehicle to be driven until it is diagnosed and repaired. Refer to
Symptoms - Hydraulic Brakes (See: Brakes and Traction Control/Hydraulic System/Testing and Inspection/Symptom Related Diagnostic
Procedures/Symptoms - Hydraulic Brakes) .
15. Drive the vehicle to exceed 13 km/h (8 mph) to allow ABS initialization to occur. Observe brake pedal feel.
16. If the brake pedal feels spongy, repeat the automated bleeding procedure until a firm brake pedal is obtained.
