Tahoe 2WD V8-6.0L Hybrid (2008)
3. If not equipped with active fuel management, perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and
washer (707).
4. Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten the sensor to 35 N.m (26 lb ft).
5. Install the intake manifold. Refer to Intake Manifold Replacement (RPOs LY2/LY6) (See: Engine, Cooling and Exhaust/Engine/Intake
Manifold/Service and Repair)Intake Manifold Replacement (RPOs LC9/LMG/LY5/L76) (See: Engine, Cooling and Exhaust/Engine/Intake
Manifold/Service and Repair)Intake Manifold Replacement (RPO L92 - First Design) Intake Manifold Replacement (RPO L92 - Second Design).
