Tahoe 2WD V8-6.0L Hybrid (2008)
Ignition Coil: Service and Repair
Ignition Coil Replacement
Removal Procedure
1. Remove the intake manifold sight shield, as required.
2. If replacing one of the rear 2 ignitions coils on the right side perform steps 3 through 12, otherwise proceed to step 13.
3. Disconnect the engine wiring harness electrical connector (3) from the drive motor generator power inverter module cover.
4. Loosen the drive motor generator power inverter module cover bolt (1).
5. Remove the drive motor generator power inverter module cover (2).
6. Remove the generator control module 3 phase cable clip nut (1).
7. Remove the generator control module 3 phase cable clip from the engine bracket (2).
8. Reposition the generator control module 3 phase cables out of the way.
9. Remove the right wheelhouse liner.
