Tahoe 2WD V8-6.0L Hybrid (2008)
1. Position the ignition coil to the ignition coil bracket.
Notice: Refer to Fastener Notice.
2. Install the ignition coil bolts.
Tighten the bolts to 10 N.m (89 lb in).
3. Install the spark plug wire to the ignition coil.
4. Inspect the spark plug wire for proper installation:
*
Push sideways on each boot in order the inspect the seating.
*
Reinstall any loose boot.
5. Connect the ignition coil wiring harness electrical connector (1) to the ignition coil.
6. If replacing one of the rear 2 ignitions coils on the right side perform steps 7 through 16, otherwise proceed to step 17.
