Tahoe 2WD V8-6.0L Hybrid (2008)
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor Replacement
Front Wheel Speed Sensor Replacement
Caution: Refer to Brake Dust Caution .
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
3. Remove the front disc brake rotor. Refer to Front Brake Rotor Replacement (1500 Series) (See: Brakes and Traction Control/Disc Brake
System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Front Brake Rotor Replacement (1500 Series))Front Brake Rotor
Replacement (2500 Series) (See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Front Brake Rotor Replacement (2500 Series)) .
4. Remove the wheel speed sensor (WSS) cable mounting clip from the steering knuckle.
5. Remove the WSS cable mounting clip from the upper control arm.
6. Remove the WSS cable mounting clip from the frame attachment point.
7. Disconnect the WSS cable electrical connector.
8. Remove the WSS mounting bolt.
NOTICE: Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of
the bore. Prying will cause the sensor body to break off in the bore.
9. Remove the WSS from the hub/bearing assembly.
Installation Procedure
