Tahoe 2WD V8-6.0L Hybrid (2008)
2. Position the power steering assist motor (2) and seal (3) to the steering gear.
Notice: Refer to Fastener Notice .
3. Install the power steering assist motor bolts (1).
Tighten the bolts to 13 N.m (115 lb in).
4. Route the power steering assist motor electrical harness back through the engine compartment to its previous position and secure the lower part of
the wiring harness to the frame.
5. Install the steering linkage shield (2) and the steering linkage shield bolts (1).
Tighten the bolts to 12 N.m (106 lb in).
Important: The power steering assist motor electrical harness connector should engage smoothly as it is pushed on. Do NOT force the
