Tahoe 2WD V8-6.0L Hybrid (2008)
3. Install the O-ring to the steering knuckle.
Notice: Refer to Fastener Notice .
4. Install the wheel speed sensor to the wheel hub and bearing.
Tighten the sensor mounting bolt to 18 N.m (13 lb ft).
5. Install the wheel hub and bearing and splash shield to the vehicle.
6. Install the wheel hub and bearing mounting bolts.
Tighten the wheel hub to knuckle bolts to 180 N.m (133 lb ft).
Important: The following service procedure applies to those vehicles equipped with 4WD.
7. Install the nut and washer retaining the wheel drive shaft assembly to the wheel hub and bearing. Refer to Wheel Drive Shaft Replacement (2500)
(See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair)Wheel Drive Shaft Replacement
(1500) ()
8. Connect the electrical connection for the wheel speed sensor.
9. Install the wheel speed sensor and brake hose mounting bracket bolt to the steering knuckle.
Tighten the bolt to 12 N.m (106 lb in).
10. Install the rotor. Refer to Front Brake Rotor Replacement (1500 Series) Front Brake Rotor Replacement (2500 Series) .
11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
12. Lower the vehicle .
