Tahoe 2WD V8-6.0L Hybrid (2008)
-
The IP harness may be in hard contact with the top rear edge (1) of the park brake assembly.
-
When releasing the park brake pedal, the moving part (1) at the end of the park brake release cable may be coming into hard contact with the IP
harness.
If a condition is suspected/found with one of the circuits running to C1 or C2 of the junction block or to the inline IP-to-body connector (C202) or at any
of these areas of concern then remove the front driver side door sill plate, driver side body hinge pillar trim panel, left IP outer trim cover and perform
the following steps:
1. Turn OFF the ignition and all accessories.
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in SI.
3. Visually inspect the IP harness for damage at the park brake pedal assembly. Refer to potential damage points shown in the photos - at the side and
rear of the park brake assembly. Note that damage may be hidden from view. The harness may be turned away from you, or covered by electrical
tape.
4. Operate the park brake release lever. Observe the moving part at the end of the park brake release cable as it may contact and damage the IP
harness. Inspect the IP harness at this point. Note that the damage may be hidden from view by electrical tape.
If the wiring is damaged, repair as needed. Refer to Wiring Systems and Power Management > Diagnostic Information and Procedures in SI.
5. If the harness is still in contact with a sharp edge or point of the park brake assembly, route it away from the contact point and secure it with tie
straps.
6. Protect the harness by covering the sharp edge with butyl tape or a suitable material.
