Tahoe 2WD V8-6.0L Hybrid (2008)
12. Position the inboard end (tripot end) of the halfshaft assembly into the base of the J 36652-98 for the 1500 models or J 36652-1 for the 2500,
3500 and Hummer H2 models.
13. Install the top half of the J 36652-98 for the 1500 models or J 36652-1 for the 2500, 3500 and HUMMER H2 models.
14. Align the swage ring (2) and the swage ring clamp.
15. Insert the bolts.
Hand tighten the bolts until the bolts are snug.
16. Align the following during this procedure:
*
The tripot boot (3)
*
The tripot housing (1)
*
The swage ring (2)
Tighten each bolt 180 degrees at a time. Alternate between the bolts until both sides of the top half of the tool touch the bottom half .
*
Loosen the bolts and remove the halfshaft assembly from the tool.
