Tahoe 4WD V8-393 6.5L DSL Turbo VIN S (1995)
Rear Door Panel: Service and Repair
Main Panel
Typical Rear Door Trim Panel
Tool Required: J 38778 Trim Panel Remover.
Remove or Disconnect
1. Door handle bezel. Refer to Inside Handle Bezel.
2. Window regulator handle (if equipped). Refer to Window Regulator Handle.
3. Speaker grill and speaker (if equipped).
4. Trim panel armrest screws.
5. Trim panel from the door.
^
Carefully pry the retainers from their seats using J 38778.
^
Disconnect courtesy light connector (if equipped).
^
Disconnect power window switch (if equipped).
^
Disconnect speaker wiring (if equipped).
6. Retainers from trim panel.
7. Courtesy lamp lens. Refer to Courtesy Lamp.
8. Power window switch (if equipped). Refer to Power Window Switch.
Install or Connect
1. Retainers to trim panel.
2. Power window switch (if equipped). Refer to Power Window Switch.
3. Courtesy Lamp lens or reflector to trim panel.
4. Speaker and speaker grill(if equipped).
5. Trim panel to the door.
^
Connect speaker and power window switch connectors (if equipped).
^
Connect Courtesy lamp connector.
^
Align retainers with holes in door.
^
Carefully apply pressure to seat retainers.
6. Window regulator handle (it equipped). Refer to Window Regulator Handle.
7. Trim panel arm rest screws.
Tighten: Trim panel armrest screws to 1.9 Nm (17 lbs. in.).
8. Door handle bezel. Refer to Inside Handle Bezel.
