Tahoe 4WD V8-393 6.5L DSL Turbo VIN S (1995)
5. With the compressor mounted to the J 25008-A Holding Fixture, position the Rotor and Bearing Assembly on the front head. Using Rotor and
Bearing Installer J 9481-A and Universal Handle J 29886 drive the rotor and bearing assembly onto the front head. With the Installer assembled to
the Handle as shown in the illustration, force will be applied to the inner race of the bearing when installing the assembly onto the front head of the
compressor.
6. Install rotor and bearing assembly retainer ring, using Snap Ring Pliers J 6083.
7. Reinstall clutch plate and hub assembly as described previously.
