Tahoe 4WD V8-393 6.5L DSL Turbo VIN S (1995)
Fig. 10 Ball guide installation
3. Install balls in ball guide alternately by color, retain in guide with petroleum jelly.
4. Connect ball guide, clamp and screws to rack piston.
5. Lubricate stub shaft, valve spool and seals with power steering fluid, then install into valve body.
6. Connect valve body, seal, worm shaft, races and roller bearing.
Fig. 11 Needle bearing installation
7. Install seal on adjuster plug, then needle bearing in adjuster plug using J-8524-1 and J-7079-2 or equivalent.
8. Install seal, washer and retaining ring in adjuster plug.
CAUTION: Retainer projections must not extend beyond washer when retainer ring is seated. Washer must rotate freely.
9. Install worm shaft and valve assembly into gear housing.
Fig. 4 Adjuster plug removal
10. Install adjuster plug into gear housing using spanner wrench tool J-7624 or equivalent.
