Tahoe 4WD V8-393 6.5L DSL Turbo VIN S (1995)
7. Carrier lower mounting bolt.
8. Right side inner tie rod end from the relay rod.
9. Engine oil filter (some models).
10. Attach a transmission jack to the carrier.
11. Upper carrier mounting bolt.
12. Carrier from the vehicle.
INSTALL OR CONNECT
1. Carrier to the vehicle.
2. Carrier mounting bolts (127), nuts (129), and washers (128).
Tighten
^
Bolts (127) to 110 Nm (80 ft. lbs.).
3. Remove the transmission jack.
4. New engine oil filter (if removed).
5. Tie rod.
6. Axle tube bolts (125), nuts (130), and washers (126).
Tighten
^
Nuts (130) to specifications:
^
K2 models 100 Nm (75 ft. lbs.).
^
K3 models 145 Nm (106 ft. lbs.).
7. Vent hose.
8. Wiring.
9. Drive axle (201) to output shaft bolts (200).
Tighten
^
Bolts to 80 N.m (60 lbs. ft.).
10. Front propeller shaft to the carrier yoke.
Tighten
^
Universal joint clamp bolts to 20 Nm (15 ft. lbs.).
^
Fill the carrier with lubricant, if necessary.
11. Skid plate, if equipped.
12. Add engine oil as necessary.
Carrier Case Bushing Replacement
