Tahoe 4WD V8-393 6.5L DSL Turbo VIN S (1995)
Pinion Bearing: Service and Repair
Corporate and Eaton
7 1/2 - 8 5/8 Inch Ring Gear
PINION DEPTH ADJUSTMENT
If original ring gear and pinion assembly and rear pinion bearing are to be reused, original depth adjusting shim can be used. However, if
ring gear and pinion or rear pinion bearing are replaced, pinion depth must be adjusted using following procedures.
1. Install pinion bearing races to be used in housing using suitable driver.
2. Lubricate pinion bearings and install bearings in races.
3. Mount depth gauging jig in housing, noting the following:
Fig. 16 Pinion depth gauge tool installation. Models w/7-1/2 inch ring gear
a.
On models with 7 1/2 & 7 5/8 inch ring gear, use gauge assembly tool No. J-23597-01 or equivalent, Fig. 16. Follow all tool manufacturer's
recommendations when installing gauge assembly.
