Tahoe 4WD V8-393 6.5L DSL Turbo VIN S (1995)
Important:
Do not pound on to disconnect.
3. Propeller shaft.
^
Compress the propeller shaft forward, enough to disengage, then move the propeller shaft rearward.
^
Avoid dropping cap assemblies from the yoke ends.
Clean
All parts with an approved solvent.
Inspect
^
Splines for damage, wear, burrs, and twisting.
^
Universal joint bearings for wear.
^
Propeller shaft for any evidence of damage.
Install or Connect (Figure 1)
^ Extend the propeller shaft to its full length, then compress it about half its stroke.
1. Propeller shaft to front axle.
^
Line up the reference marks made previously.
2. Retainers and bolts.
Tighten:
^
Retainer bolts to 20 Nm (15 lb.ft).
3. Propeller shaft to transfer case.
^
Line up the reference marks made previously.
^
Adjust the propeller shaft length.
4. Retainers and bolts.
Tighten:
^
Retainer bolts to 20 Nm (15 lb.ft).
5. Skid plate (if applicable). Refer to Section 4C.
Slip Yoke Splines
Apply chassis lubricant at the slip spline grease fitting until the grease begins to leave through the vent hole. If the slip spline is dry or corroded, it may
be necessary to disconnect the propeller shaft from the vehicle, remove the slip yoke, and wire brush the affected area. Wipe clean before installation.
