Tahoe 4WD V8-393 6.5L DSL Turbo VIN S (1995)
Torque Sequence, Control Valve And Switch Assembly
NOTICE: The use of a honing stone, fine sandpaper or crocus cloth is not recommended for servicing stuck valves. All valve lands have sharply
machined comers that are necessary for cleaning the bore. If these corners are rounded, foreign material could wedge between the valve and the bore
causing the valve to stick. If it is found necessary to clean a valve, micro fine lapping compound 900 grit (J 38459) or finer should be used. Too much
lapping of the valve will cause excessive clearances and increase the chance of a valve not operating.
CLEAN
^
Control valve assembly and accumulator housing (51) thoroughly in clean solvent.
^
Air dry.
