Tahoe 4WD V8-393 6.5L DSL Turbo VIN S (1995)
8.
Carefully apply a bead of silicone sealant P/N 12345739 (or GE-162 sealant or equivalent) in the groove of the NEW cover (Figure 2).
Remove any excess sealant that is outside of the groove.
IMPORTANT:
Only apply enough sealant to fill the groove in the cover.
9.
Install the new cover on the wiper motor housing and install the three (3) new screws. Tighten the screws to 2.6 Nm (23 lbs. in.).
10.
Reconnect the wiper motor electrical connector to the wiper motor assembly and install the CPA.
11.
Turn the ignition key to the "ON" position and check wiper system for proper operation (delay/low/high (etc.).
12.
Install the GM Campaign Identification label.
Campaign Identification Label
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label".
Each label provides a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service, This
information may be inserted with a typewriter or a ball point pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in by the
customer for periodic servicing. When installing the Campaign Identification Label, be sure to pull the tab to allow adhesion of the clear protective
covering. Additional Campaign Identification Labels can be obtained from VISPAC Incorporated by calling 1-800-269-5100 (Monday-Friday, 8:00 a.m.
to 430 p.m. EST). Ask for item number S-1015 when ordering.
Apply the "Campaign Identification Label" only on a clean, dry surface.
Claim Information
