Tahoe 4WD V8-5.3L (2007)
Differential Mount: Service and Repair
Differential Carrier Assembly Bushing Replacement
Tools Required
^
J 33791 Carrier Bushing Remover/Installer
^
J 36616 Axle Mount Bushing Remover/Installer
Removal Procedure
1. Remove the differential carrier assembly.
2. Remove the upper differential carrier assembly bushing by performing the following steps:
1. Install the J 36616-2 (1), the J 33791-1 (2), the thrust bearing (3), the J 21474-18 (4), and the forcing screw as shown.
2. Remove the upper differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
