Tahoe 4WD V8-6.2L (2009)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the wheel speed sensor bolt (1) and tighten to 9 Nm(80 lb in).
3. Connect the wheel speed sensor electrical connector (1).
4. Install the wheel speed sensor electrical connector and sensor harness clips (2) to the inboard frame rail.
5. Perform the Diagnostic System Check - Vehicle (with HP2) (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic
System Check - Vehicle)Diagnostic System Check - Vehicle (without HP2) (See: Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnostic System Check - Vehicle).
Greater than/Equal to 3900 kg (8600 lb) GVW
Rear Wheel Speed Sensor Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning (See: Service Precautions/Technician Safety Information/Brake Dust Warning).
