Tahoe 4WD V8-6.2L (2009)
11. Fill the rear axle. Refer to Differential Oil Replacement (10.5 Inch Axle) (See: Maintenance/Fluids/Fluid - Differential/Service and
Repair/Removal and Replacement/Differential Oil Replacement (10.5 Inch Axle))Differential Oil Replacement (8.6 Inch Axle) (See:
Maintenance/Fluids/Fluid - Differential/Service and Repair/Removal and Replacement/Differential Oil Replacement (8.6 Inch Axle))Differential
Oil Replacement (9.5LD Inch Axle) (See: Maintenance/Fluids/Fluid - Differential/Service and Repair/Removal and Replacement/Differential Oil
Replacement (9.5LD Inch Axle)).
12. Lower the vehicle.
Greater than/Equal to 3900 kg (8600 lb) GVW
Rear Wheel Speed Sensor Ring Replacement
Special Tools
*
J 2619-01 Slide Hammer
*
J 8092 Driver Handle
*
J 21128 Axle Pinion Oil Seal Installer
*
J 23690 Bearing Installer
*
J 45857 Tone Wheel and/or Bearing Remover
*
J 45860 Tone Ring Installer
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Ring Replacement .
4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) (See: Transmission and
Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch
Axles))Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) (See: Transmission and Drivetrain/Differential Assembly/Service
and Repair/Removal and Replacement/Rear Drive Axle/Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle)).
5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Axle Shaft/Service and Repair).
6. Remove the axle shaft seal, the bearing and the wheel speed sensor ring from the axle housing using the J 45857 (1) and the J 2619-01 (2).
Installation Procedure