Tahoe 4WD V8-6.2L (2009)
6. Turn the wheel hub over and install the inner bearing cup.
7. Using the J 24427 - installer (2) and the J 8092 - handle (1), install the inner bearing cup into the wheel hub.
8. Install the inner bearing.
Note: Ensure the seal is fully seated in the hub bore.
9. Using the J 44420 - installer (2) and the J 8092 - handle (1), install the new oil seal.
10. Install the rotor, if necessary. Refer to Rear Brake Rotor Replacement (1500 Series) (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor Replacement (1500 Series))Rear Brake Rotor Replacement (2500
Series) (See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor
Replacement (2500 Series)).
11. Apply a light coat of high melting point EP bearing lubricant to the axle housing spindle.
