Tracker 2WD L4-1.6L VIN 6 (2000)
Hood Hinge: Service and Repair
Hood Hinge Replacement
Removal Procedure
1. Raise and suitably support the hood.
2. Install protective covers over the front fenders in order to prevent paint damage.
3. Mark the position of the following in order to ease in the reassembly process:
*
The hood hinges (4) to the hood (1)
*
The hood hinges (4) to the cowl
Notice: Refer to Tape Corners of Panel Notice in Cautions and Notices.
4. Remove the 2 bolts (3) which secure each hood hinge (4).
5. Remove the hood (1) from the vehicle.
6. Remove the 2 bolts (5) which secure the hood hinge (4).
Notice: Anti-corrosion compounds have been applied to the interior surfaces of some metal panels to provide rust resistance. When servicing
these panels in areas on which this material has been disturbed, or when installing new panels, avoid corrosion damage by coating with
anti-corrosion compound.
7. Remove the hood hinge (4) from the vehicle.
Installation Procedure