Tracker 2WD L4-1.6L VIN 6 (2000)
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the nut (6) to the pivot pin bolt.
^
Tighten the nut to 24 Nm (17 ft. lbs.).
7. Install the brake pedal push rod clevis pin.
8. Install the retainer to the clevis pin.
9. Connect the stoplamp switch.
10. Hook the return spring on the brake pedal lever.
11. Measure the brake pedal travel. Adjust if necessary. Refer to Brake Pedal Travel.
12. Measure the distance from the stoplamp switch to the brake pedal stopper. Adjust if necessary. Refer to Stoplamp Switch Adjustment.
