Tracker 2WD L4-1.6L VIN 6 (2000)
Installation Procedure
1. Install the 2 brake pad insulators (1) to the brake pads (3,4).
2. Install the 2 brake pad retainers (4).
Important: Install the brake pad with the wear indicator to the inner pad position.
3. Install the 2 brake pads to the caliper.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Ensure the boots fit into the grooves securely.
4. Install the caliper (1) to the caliper bracket. Secure with 2 caliper pin bolts.
^
Tighten the caliper pin bolts to 27 Nm (20 ft. lbs.).
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
6. Lower the vehicle.
7. Fill the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
8. Start the engine.
9. Press the brake pedal several times in order to position the caliper piston.
10. Burnish the pads. Refer to Burnishing Pads and Rotors.
