Tracker 2WD L4-1.6L VIN 6 (2000)
1. Install the caliper (1) to the caliper bracket. Secure with 2 caliper pin bolts.
^
Tighten the caliper pin bolts to 27 Nm (20 ft. lbs.).
2. Install the brake hose to the caliper.
3. Install the 2 washers and the brake hose fitting.
^
Tighten the fitting to 23 Nm (17 ft. lbs.).
4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
5. Lower the vehicle.
6. Fill the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
Caution: If any brake component is repaired or replaced such that air is allowed to enter the brake system, the entire bleeding procedure MUST be
followed. Unapproved or partial bleed procedures can allow air to remain in the brake system. This could result in reduced braking performance and
possible personal injury.
Notice: If any brake component is repaired or replaced such that air is allowed to enter the brake system, the entire bleeding procedure must be
followed.
7. Bleed the brake system. Refer to Hydraulic Brake System Bleeding in Hydraulic Brakes.
