Tracker 2WD L4-1.6L VIN 6 (2000)
Crankshaft Seal Retainer: Service and Repair
Removal Procedure
1. Remove the engine oil pan. Refer to Oil Pan Replacement.
2. Remove the flywheel from the engine. Refer to Engine Flywheel Replacement.
3. Remove the 5 rear main oil seal bolts.
4. Remove the rear main oil seal housing and gasket.
5. Remove the rear main oil seal from the housing.
Installation Procedure
1. Install the new rear main seal (1) to the rear main seal housing.
2. Lubricate the new crankshaft rear main oil seal with Chassis Grease GM P/N 1051344 or equivalent.
3. Install the rear main seal housing to the cylinder block with a new gasket.
Notice: Refer to Fastener Notice in Service Precautions.
