Tracker 2WD L4-1.6L VIN 6 (2000)
Air Door Cable: Service and Repair
Mode Control Cable Replacement
REMOVAL PROCEDURE
1. Remove the mode control cable from the clip (2) at the heater case. Unhook the cable from the mode door pin.
2. Remove the heater control assembly (6) from the Instrument Panel (IP) in order to gain access to the cable. Do not remove the heater control
assembly from the vehicle.
3. Gently pry the mode control cable (4) sheath from the heater control unit. Unhook the cable from the lever arm.
IMPORTANT: Note the routing position of the cable in order to facilitate installation.
4. Remove the mode control cable from the instrument panel.
INSTALLATION PROCEDURE
