Tracker 2WD L4-1.6L VIN 6 (2000)
1. Properly route and install the power steering pump drive belt (1) on the power steering pump and the crankshaft pulleys.
Notice: Refer to Fastener Notice in Service Precautions.
2. Adjust the power steering pump drive belt to obtain 6 - 9 mm (0.24 - 0.35 inch) deflection.
^
Tighten the power steering pump mounting bolts to 30 Nm (22 ft. lbs.).
A/C COMPRESSOR DRIVE BELT
Removal Procedure
1. Loosen the A/C compressor mounting bolts.
2. Pivot the A/C compressor towards the engine in order to relieve the tension on the belt.
3. Remove the A/C compressor drive belt (1) from the pulleys.
Installation Procedure