Tracker 2WD L4-1.6L VIN 6 (2000)
1. Properly route and install the A/C compressor drive belt (1) on the A/C compressor, the power steering (if equipped), and the crankshaft pulleys.
2. Adjust the A/C compressor drive belt to obtain 6 - 9 mm (0.24 - 0.35 inch) deflection.
^
Tighten the A/C compressor mounting bolts to 18 - 28 Nm (13 - 20 ft. lbs.).
GENERATOR DRIVE BELT
Removal Procedure
1. Remove the power steering pump and the AJC compressor drive belt.
2. Loosen the generator mounting bolts.
3. Pivot the generator towards the engine and remove the accessory drive belt.
Installation Procedure
1. Properly route and install the generator drive belt on the pulleys.
2. Adjust the drive belt tension to obtain the specified deflection.
Used Belt Deflection 6 - 8 mm (0.20 - 0.31 inch)
New Belt Deflection 5 - 7 mm (0.20 - 0.27 inch)