Tracker 2WD L4-1.6L VIN 6 (2000)
Wheel Fastener: Service and Repair
Rear
Removal Procedure
-
Tools Required
-
J34866 Wheel Hub Remover
-
J2619-01 Slide Hammer
-
J6627-A Wheel Stud Remover
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the brake drum. Refer to Brake Drum Replacement in Drum Brakes.
4. Remove the 4 rear axle shaft retaining nuts (2).
5. Pull the rear flange (1) out partially in order to access the wheel studs using the J34866 with the J2619-01. Refer to Axle Shaft Replacement in
Rear Drive Axle.
6. Use the J6627-A in order to remove the wheel stud.
Installation Procedure