Tracker 2WD L4-1.6L VIN 6 (2000)
1. Refer to Harness Routing Views in Diagrams.
Disconnect the following electrical connectors:
^
The Intake Air Temperature (IAT) sensor
^
The Mass Air Flow (MAF) sensor
^
The EVAP tank pressure control solenoid valve
^
The EVAP canister vent solenoid
^
The EVAP canister purge valve
^
The Throttle Position Sensor (TPS) (8)
^
The Idle Air Control (IAC) valve (6)
^
The power steering pressure switch
^
The generator
^
The starter motor
^
The Crankshaft Position (CKP) sensor
^
The Exhaust Gas Recirculation (EGR) valve (1)
^
The Manifold Absolute Pressure (MAP) sensor (11)
^
G102
^
G103 (10)
^
The noise suppressor filter
^
The Engine Coolant Temperature (ECT) sensor (2)
^
The Heated Oxygen (HO2S1) sensor
^
The heated oxygen (HO2S2) sensor (California emissions only)
^
The oil pressure switch
^
The Camshaft Position (CMP) sensor
^
The ignition coils
^
The fuel injector harness, C102 (3)
^
The back up lamp switch
^
The transmission range switch The input shaft speed sensor
^
The 4 wheel drive low switch
^
The 4 wheel drive switch
^
The Vehicle Speed Sensor (VSS)
^
The output shaft speed sensor
^
The Torque Converter Clutch (TCC) solenoid/shift solenoid
