Tracker 2WD L4-1.6L VIN 6 (2000)
6. Inspect the speedometer driven gear for excessive wear or damage. Replace the speedometer driven gear if necessary.
Installation Procedure
^
Tools Required
-
J 34833 Valve Guide Remover Valve Guide Remover
-
J 36850 Transjel Transmission Assembly Lubricant
1. Apply the J 36850 to the new speedometer driven gear lip seal.
2. Install the new speedometer driven gear lip seal into the speedometer driven gear case (2) using the J 34833 Valve Guide Remover
3. Install the speedometer driven gear (1) into the speedometer gear case (2). Secure the speedometer driven gear with one roll pin.
Notice: Refer to Fastener Notice Service Precautions.
4. Install the speedometer driven gear case to the extension case and the ground wire; secure with the 1 bolt (1).
^
Tighten the speedometer driven gear case retaining bolt to 12 Nm (106 inch lbs.).
5. Connect the vehicle speed sensor to the speedometer driven gear case.
6. Lower the vehicle.
